Last modified 4 years ago
Connecting the FireFly Programmer Board to a FireFly Node
- Make sure your board is setup like below:
- Connect the USB, Programming and Debugging Cable like so:
- Connect the Programming and Debugging Ribbon Cables to the node:
- Make sure the programming cable is aligned correctly since it may be a 6 pin header and a 10 pin cable. The cable should be lined up with the center pins:
Attachments
-
programmer.jpg
(122.8 KB) -
added by agr 4 years ago.
Programmer Board
-
wires.jpg
(70.3 KB) -
added by agr 4 years ago.
Connect Wires
-
disorientation.jpg
(76.0 KB) -
added by agr 4 years ago.
Attach to Board
-
connect-1.jpg
(73.2 KB) -
added by agr 4 years ago.
Connection to Node (no zoom)
-
connect-zoom.jpg
(70.8 KB) -
added by agr 4 years ago.
Align those pins!
