Connecting the FireFly Programmer Board to a FireFly Node
- Make sure your board is setup like below:
- Connect the USB, Programming and Debugging Cable like so:
- Connect the Programming and Debugging Ribbon Cables to the node:
- Make sure the programming cable is aligned correctly since it may be a 6 pin header and a 10 pin cable. The cable should be lined up with the center pins:
Attachments
- programmer.jpg (122.8 kB) -
Programmer Board
, added by agr on 08/20/07 16:44:02. - wires.jpg (70.3 kB) -
Connect Wires
, added by agr on 08/20/07 16:44:31. - disorientation.jpg (76.0 kB) -
Attach to Board
, added by agr on 08/20/07 16:44:51. - connect-1.jpg (73.2 kB) -
Connection to Node (no zoom)
, added by agr on 08/20/07 16:45:17. - connect-zoom.jpg (70.8 kB) -
Align those pins!
, added by agr on 08/28/07 16:43:26.
Download in other formats:
